HP Remote Graphics Software 5.4.8 User Guide

NOTE: As noted earlier,
Rgreceiver.Session.<N>.VirtualDisplay.IsPreferredResolutionEnabled takes
precedence over Rgreceiver.IsMatchReceiverResolutionEnabled. Therefore, if the former
property is enabled (as listed in paragraph 2 above), the latter property is a “don’t care”, and its
setting is ignored.
If the above conditions are met, the Receiver will determine the physical displays that are contained
within the Receiver Remote Display Window specified by these properties:
●
Rgreceiver.Session.<N>.RemoteDisplayWindow.X
●
Rgreceiver.Session.<N>.RemoteDisplayWindow.Y
●
Rgreceiver.Session.<N>.VirtualDisplay.PreferredResolutionWidth
●
Rgreceiver.Session.<N>.VirtualDisplay.PreferredResolutionHeight.
The Receiver will try to set the layout of the Remote Computer (Sender) physical displays to match the
physical displays contained in this window. For example, if the Receiver has the following:
●
Two physical displays in a 1x2 layout
●
An overall virtual display resolution of 2560x1024 (1280x1024x2)
●
Rgreceiver.Session.<N>.RemoteDisplayWindow.X = 1280
●
Rgreceiver.Session.<N>.RemoteDisplayWindow.Y = 0
●
Rgreceiver.Session.<N>.VirtualDisplay.PreferredResolutionWidth = 1280
●
Rgreceiver.Session.<N>.VirtualDisplay.PreferredResolutionHeight = 1024
Then the Receiver will determine that one physical display with a resolution of 1280x1024 is contained
within the window. The Receiver will try to set the layout of the Remote Computer Sender to a single
physical display and a resolution of 1280x1024.
If the following conditions are met:
1. This property is enabled.
2. Rgreceiver.IsMatchReceiverResolutionEnabled is disabled.
3. Rgreceiver.Session.<N>.VirtualDisplay.IsPreferredResolutionEnabled is
disabled.
Then this property has no affect.
NOTE: The following property, while supported, has been deprecated. HP recommends using the
per-session Remote Display Window X and Y positioning properties described in
Window placement
and size properties on page 197.
Rgreceiver.RecentWindowPositions=int vector （10 10）
Rgreceiver.RecentWindowPositions.IsMutable=bool （1）
184 Chapter 8 RGS properties