HP Remote Graphics Software 5.4.8 User Guide

●
Maximum image quality—This is the original user quality adjustment. The quality slider
adjusts the maximum image quality desired. When selecting Fixed image quality RGS will
maintain the image quality specified by this control setting. When selecting Adjust image
quality RGS will use this control setting for the target image quality when the updates per second
allow.
●
Fixed image quality—RGS maintains the image quality specified by the Maximum image
quality slider described above. This selection is the default and will provide the best interactive
experience in high bandwidth and/or low latency network environments. Select this choice for the
normal RGS behavior as in previous versions.
●
Adjust image quality—When selected, RGS will begin to degrade the image quality down to
the Minimum image quality setting anytime the updates per second falls below the
Minimum update rate. This selection is useful in low bandwidth and/or high latency network
environments. By adjusting these settings, a better interactive experience is achieved.
◦
Minimum image quality—The Minimum image quality control specifies the lowest
quality level that will be used during the automatic adjustment. The Minimum image
quality is absolute - the system will not lower quality below the specified value. Valid
settings are from 0 to 100.
◦
Minimum update rate—The Minimum update rate controls how aggressively the
image quality is reduced. Specifying a Minimum update rate of 30 will drive the most
aggressive quality reduction. The Minimum update rate is a target. The available
bandwidth may be too low to maintain the target rate. Valid settings are 0 to 30 updates per
second.
122 Chapter 6 Advanced capabilities