HP Remote Graphics Software 7.0

USB properties
Table 9-6 USB properties
Rgreceiver.Usb.IsMutable
1=A user can modify the Remote USB settings in the RGS Receiver Control Panel (default).
0=A user cannot modify the Remote USB settings in the RGS Receiver Control Panel.
Rgreceiver.Usb.IsEnabled
1=Remote USB is enabled (default).
0=Remote USB is disabled.
Rgreceiver.Usb.ActiveSession
This property specifies which remote computer to attach USB devices to for Directory Mode. 0 is the first remote computer, 1
is the second remote computer, and so on.
NOTE: After changing this setting, you must disconnect and then reconnect all RGS connections.
Network properties
Table 9-7 Network properties
Rgreceiver.Network.Timeout.IsMutable
1=A user can modify the network timeout settings in the RGS Receiver Control Panel (default).
0=A user cannot modify the network timeout settings in the RGS Receiver Control Panel.
Rgreceiver.Network.Timeout.IsGuiEnabled
1=Enables the warning dialog for when the RGS connection is about to time out due to the inability to contact the RGS
Sender (default).
0=Disables this warning dialog.
Rgreceiver.Network.Timeout.Error
This property sets the time in milliseconds that the RGS Receiver will wait before ending the connection after failing to detect
the RGS Sender. The default is 30000 milliseconds (30 seconds).
Rgreceiver.Network.Timeout.Warning
This property sets the time in milliseconds that the RGS Receiver will wait before displaying a warning dialog to the local
user after failing to detect the RGS Sender. The default is 2000 milliseconds (2 seconds).
Rgreceiver.Network.Timeout.Dialog
This property sets the time in milliseconds that the RGS Receiver will wait for a response to a dialog being displayed on the
remote computer (such as an authentication dialog). The request will be canceled if there is no response. The default is
15000 milliseconds (15 seconds).
Rgreceiver.Network.Port
This property specifies the port used for communication between the RGS Receiver and RGS Sender. This setting much
match the port setting on the RGS Sender. The default is 42966.
Rgreceiver.Network.HPVelocity.Mode
3=HP Velocity operates in Active mode (default).
1=HP Velocity operates in Monitor mode.
0=HP Velocity is disabled.
82 Chapter 9 RGS properties