HP Remote Graphics Software 7.0

Command line syntax
RGS command line options must be preceded by a /z flag and be enclosed in double quotes, with no
space before or after the opening double quote and no space before the closing double quote. If
using multiple commands, separate them with a single space. See the example below:
ReceiverSetup.exe /z"/autoinstall /agreetolicense"
If you need to include a double quote as part of a parameter (such as for a folder path), then you
should precede each of those double quotes with a backwards slash like in the following example:
ReceiverSetup.exe /z"/autoinstall /agreetolicense /folder=\"C:\Program
Files\Hewlett-Packard\Remote Graphics Receiver\""
NOTE: Command line options intended for the MSI installer should precede the /z flag, be
separated by a space, and not be enclosed in quotes. MSI command line options should be used by
advanced users only. The only suggested option is /s, which hides prompts and dialogs.
RGS Receiver installation command line options
Table 3-1 RGS Receiver installation command line options
Command Description
/autoinstall
This option performs one of the following:
●
Installs the RGS Receiver if it is not currently installed.
●
Updates the RGS Receiver if a prior version is currently
installed.
●
Exits without changes if the version being installed is the
same as the version that is currently installed.
The RGS Receiver will not be reinstalled if the version being
installed is older than the version currently installed.
/agreetolicense
Use of this option indicates that the user agrees to the license for
use of this software. This option is required when doing an
installation.
/autoremove
Removes the RGS Receiver.
/folder=\"<folder>\"
Example: /folder=\"C:\RGS Receiver\"
Specifies the destination folder.
NOTE: The default is C:\Program Files\Hewlett-
Packard\Remote Graphics Receiver.
/usb=local
Installs USB in Local Mode.
/usb=remote
Installs USB in Remote Mode. The system will automatically
restart after the installation completes.
/usb=localRemote
Installs USB in Local/Remote Mode. The system will automatically
restart after the installation completes.
NOTE: USB is installed in Local/Remote Mode by default if no
mode is specified.
/clipboard
Enables Remote Clipboard.
/noreboot
Causes the system to not reboot after an installation or
uninstallation.
/viewlicense
Displays the EULA (End User License Agreement) for use of this
software.
14 Chapter 3 Installing and activating RGS