HP Remote Graphics Software 7.0

Table 9-16 RGS Sender properties (continued)
0=HP Velocity is disabled.
NOTE: See HP Velocity documentation for more information.
Rgsender.Network.HPVelocity.TargetLossRate
3=The target loss rate used by HP Velocity is 0.04% (default).
2=The target loss rate used by HP Velocity is 0.1%.
1=The target loss rate used by HP Velocity is 0.2%.
0=The target loss rate used by HP Velocity is 0.4%.
NOTE: See HP Velocity documentation for more information.
Rgsender.Network.HPVelocity.NetworkInterface
NOTE: This property only applies to Linux.
This property specifies the active network interface. The default is eth0.
Rgsender.Network.HPVelocity.EnablePlp
1=Enables packet loss protection for HP Velocity (default).
0=Disables packet loss protection for HP Velocity.
NOTE: See HP Velocity documentation for more information.
Rgsender.Network.HPVelocity.EnableLiveTcp
1=Enables LiveTCP for HP Velocity (default).
0=Disables LiveTCP for HP Velocity.
NOTE: See HP Velocity documentation for more information.
Rgsender.Network.HPVelocity.LiveTcpLatencyThreshold
This property sets the LiveTCP latency threshold in milliseconds. The default is 30 milliseconds.
Rgsender.Network.HPVelocity.LiveTcpCongestionControlAlgorithm
1=Friendly.
0=Aggressive (default).
NOTE: See HP Velocity documentation for more information.
Rgsender.IsBlankScreenAndBlockInputEnabled
1=The remote computer’s screen will blank and it’s keyboard and mouse will disable when a primary user connects (default).
0=The remote computer’s screen will not blank and it’s keyboard and mouse will not disable.
Rgsender.Usb.Acl.RulesetPat
This property specifies the name of the XML file that implements the Remote USB Access Control List (ACL). The default is
hprDefaultUsbAcl.xml.
Rgsender.Usb.Acl.SchemaPath
This property specifies the name of the schema file that accompanies the Remote USB XML file. The default is
hprUsbAcl.xsd.
Rgsender.Usb.Acl.RulesetErrorTimeout
RGS Sender properties 89