HP Rack and Power Manager User Guide

Installation
9. Read the information, and click Done.
10. To complete installation of the System Agent, run the following commands from the
NetWare server Console:
<INSTALL_PATH>/NWCRPMIN.NCF
CRPMLD.NCF
NOTE: The System Shutdown Agent screen appears, indicating that the System Agent has been
loaded. In normal operation, this screen might be blank.
11. To complete installation of the Serial Relay Agent:
a. Run the following command from the NetWare server Console:
<INSTALL_PATH>/NWCRPMIN.NCF
The Serial Relay Agent Setup screen appears, allowing for configuration of the Serial
Relay Agent. If it is necessary to reconfigure the Serial Relay Agent after the
installation, run
SRASETUP.NLM from the directory in to which the software was
installed (usually
SYS:HP/RPM).
HP Rack and Power Manager User Guide 2-43
HP CONFIDENTIAL Codename: Part Number: 311371-002 Last Saved On: 2/3/04 3:12 PM