HP Rack and Power Manager User Guide

Installation
12. If you are installing the Serial Relay Agent, the Setup HP Serial Relay Agent dialog box
appears. Select the COM port on the computer to which the UPS is attached in the Serial
Port dropdown box, then click OK.
A message appears, asking to start the Serial Relay Agent. Click Yes. The installation
program attempts to communicate with the UPS. After communication is established, the
Service Start screen appears.
NOTE: If the Serial Relay Agent fails to communicate with the UPS, refer to Chapter 6,
“Troubleshooting.”
HP Rack and Power Manager User Guide 2-15
HP CONFIDENTIAL Codename: Part Number: 311371-002 Last Saved On: 2/3/04 3:12 PM