HP Rack and Power Manager User Guide

Overview
Configuration C
Figure 1-4 illustrates a server that is plugged into a load segment of a UPS. Both the UPS and
the server are directly connected to the network. The UPS is monitored by a Management
Server that is located elsewhere on the network. The server has an installed System Agent
that receives commands, such as displaying a pop-up message or shutting down the operating
system, from the Management Server.
NOTE: Installed agents must be associated with the correct server or UPS load segment in HP Rack
and Power Manager. For information on associating agents, refer to “Attached Agents Screen” in
Chapter 5.
Figure 1-4: Configuration C
Item Description
1 HP Rack and Power Management Server*
2 Additional servers power protected by a single UPS (each server requires installation of the
System Agent)
3 Power protected server (requires installation of the System Agent)
4 UPS with an HP SNMP Adapter Card installed
5 Utility power feed
*A dedicated Management Server is not required.
1-10 HP Rack and Power Manager User Guide
HP CONFIDENTIAL Codename: Swordfish Part Number: 311371-002 Last Saved On: 2/3/04 3:10 PM