HP Rack and Power Manager User Guide
Configuration
3. Enter the name that HP Rack and Power Manager will mark messages as being sent from.
4. Click Apply to accept the information that has been entered, or click Undo Changes to
reject all changes and keep the box open.
NOTE: Only servers using SMTP are supported.
Configuration Screen
The Configuration screen is only displayed for users who have administrator rights. The
Server Properties box on the Configuration screen enables you to update the Management
Server configuration.
To update the configuration:
1. Select one of the following:
— Standard IP Routing Only—Enables you to enter a host name or IP address in any
field that requires a device address. The IP address or host name is stored, depending
on what you entered. If you have a mixed network configuration (for example, static
IP addresses for servers and dynamic IP addresses for workstations), select this
option and enter the host name when appropriate.
— Enable DNS Resolution—Enables you to enter a host name in any field that requires
a device IP address. If an IP address is entered, a reverse DNS lookup is performed
and only the host name is stored.
NOTE: The Management Server should be configured to support DNS resolution.
2. Enter the number of seconds that should elapse before HP Rack and Power Manager
pages are refreshed.
3. Click Apply to accept the information that has been entered, or click Undo Changes to
reject all changes and keep the box open.
4-24 HP Rack and Power Manager User Guide
HP CONFIDENTIAL Codename: Swordfish Part Number: 311371-002 Last Saved On: 2/3/04 3:15 PM