HP PS1810-24G Quick Setup Guide and Safety/Regulatory Information (5998-4024)

For additional Safety and Regulatory information, refer to the Safety and Regulatory documentation included with your switch,

to the safety and regulatory documentation on the HP web site at www.hp.com/support/Safety-Compliance-EnterpriseProducts,

and to the switch Installation and Getting Started Guide that can be found on the HP Networking web site: www.hp.com/

networking/support.

Product Specifications

Chinese Altitude Warning

Electrical:

AC voltage:

Maximum current:

Frequency range:

100-127 / 200-240

0.4 A / 0.3 A

50 / 60 Hz

This switch automatically adjusts to any voltage between 100-127

and 200-240 volts and either 50 or 60 Hz.

Environmental:

Operating Temperature: 0°C to 40°C (32°F to 104°F)

Relative humidity: 15% to 95% at 40°C (104°F), non-condensing

Non-Operating Temperature: -40°C to 70°C (-40°F to 158°F)

Non-Operating Relative humidity: 15% to 90% at 65°C (149°F), non-condensing

Maximum Operating Altitude: Up to 3 km (10,000 ft)

Note: The operating maximum altitude should not exceed that

of any accessory being connected to the switch.

Safety:

Standards:

Lasers:

EN60950-1:2006+A11:2009+A1:2010+A12:2011 / IEC60950-1:2005;

Am 1:2009 CSA22.2 No. 60950-1-07 2nd; UL60950-1 2nd

EN 60825-1:2007 / IEC 60825-1:2007 Class 1; Class 1 Laser

Products / Laser Klasse 1 (Use only supported HP SFPs)

HP PS1810-24G Switch (J9834A):

WARNING

FOR INDOOR USE ONLY. The switch, AC power cord, and all connected cables are not designed for outdoor use.

Russia / CIS Regulatory Compliance: