HP ProLiant WS460c Gen8 Workstation Blade with WS460c Graphics Expansion Blade Maintenance and Service Guide

Removal and replacement procedures 86

Align the system board, and then slide it into place inside the base pan.

4. While holding the system board in place, turn the base pan on the side and install the two screws on the

bottom of the base pan.

5. Place the workstation blade on a flat level surface.

IMPORTANT: Install all components in the same configuration prior to removing the system

board.

6. Install the front panel/drive cage assembly ("Front panel/drive cage assembly" on page 70).

7. Install the heatsink blank ("Heatsink blank" on page 50).

8. Install the SAS controller ("SAS controller" on page 58).

9. Install and route the cables for all capacitor packs. For more information on routing the cables, see

"FBWC capacitor pack cabling (on page 101)."

10. Install all DIMMs ("DIMMs" on page 49).

11. Install all DIMM baffles ("DIMM baffles" on page 47).