HP ProLiant WS460c Gen8 Workstation Blade with WS460c Graphics Expansion Blade Maintenance and Service Guide

Removal and replacement procedures 57
To replace the component:
1. Align and install the FlexibleLOM. Press down on the handle to seat the FlexibleLOM on the system
board.
2. Install the mezzanine assembly ("Mezzanine assembly" on page 51).
3. Install the access panel ("Access panel" on page 28).
Drive backplane
To remove the component:
1. Power down the workstation blade (on page 26).
2. Remove the workstation blade (on page 28).
3. Remove the access panel ("Access panel" on page 28).
4. Remove all hard drives ("Drive" on page 46).
5. Remove all hard drive blanks ("Drive blank" on page 45).
CAUTION: Remove all hard drives and hard drive blanks before removing the hard drive
backplane.
6. Remove the front panel/drive cage assembly ("Front panel/drive cage assembly" on page 70).