HP ProLiant WS460c Gen8 Workstation Blade with WS460c Graphics Expansion Blade Maintenance and Service Guide

Removal and replacement procedures 56
2.
Install the mezzanine card in the mezzanine assembly, and then to secure the card to the mezzanine
assembly, tighten the mezzanine card screws.
The installation is complete.
FlexibleLOM
To remove the component:
1. Power down the workstation blade (on page 26).
2. Remove the workstation blade (on page 28).
3. Remove the access panel ("Access panel" on page 28).
4. Remove the mezzanine assembly ("Mezzanine assembly" on page 51).
5. Use the FlexibleLOM handle to remove the FlexibleLOM from the system board.