HP ProLiant WS460c Gen8 Workstation Blade with WS460c Graphics Expansion Blade Maintenance and Service Guide

Removal and replacement procedures 50
2.
Install the DIMM.
3. Install all DIMM baffles ("DIMM baffles" on page 47).
4. Install the access panel ("Access panel" on page 28).
5. To configure the memory mode, use RBSU ("HP ROM-Based Setup Utility" on page 88).
Heatsink blank
To remove the component:
1. Power down the workstation blade (on page 26).
2. Remove the workstation blade (on page 28).
3. Remove the access panel ("Access panel" on page 28).
4. Remove the SAS controller ("SAS controller" on page 58).
5. Remove the heatsink blank.