HP ProLiant WS460c Gen8 Workstation Blade with WS460c Graphics Expansion Blade Maintenance and Service Guide

Removal and replacement procedures 32
8.
Remove the screws (1), slide the graphics expansion blade back, and then lift it up (2) from the
workstation blade.
To replace the component, reverse the removal procedure.
WS460c Graphics Expansion Blade PCIe card cage
To remove the component:
1. Power down the workstation blade (on page 26).
2. Remove the workstation blade (on page 28).
3. Remove the WS460c Graphics Expansion Blade access panel ("WS460c Graphics Expansion Blade
access panel" on page 29).
4. Remove the screws and the front bezel.