HP ProLiant WS460c Gen8 Workstation Blade with WS460c Graphics Expansion Blade Maintenance and Service Guide

Removal and replacement procedures 30
4.
Remove the screws (1) and the front bezel (2).
5. Remove the gasket.
NOTE: A stabilizer/coupler (black) is used when coupling and stabilizing two mezzanine
pass-through cards. For a single mezzanine pass-through card, a stabilizer/coupler (clear)
enables the use of the upper mezzanine slot with other mezzanine cards.
Depending on the number of mezzanine pass-through cards used, select the appropriate
stabilizer/coupler (black or clear). A stabilizer/coupler must always be used when an expansion blade
pass-through mezzanine card is used. Retain unused stabilizer/coupler for future use with possible
configuration changes.