HP ProLiant WS460c Gen8 Workstation Blade with WS460c Graphics Expansion Blade Maintenance and Service Guide

Removal and replacement procedures 29
2.
Slide the access panel forward until it clicks into place.
WS460c Graphics Expansion Blade access panel
To remove the component:
1. Power down the workstation blade (on page 26).
2. Remove the workstation blade (on page 28).
3. Lift the access panel latch (1), and then slide the access panel to the rear (2).
4. Remove the access panel.
To replace the component, reverse the removal procedure.
WS460c Graphics Expansion Blade
To remove the component:
1. Power down the workstation blade (on page 26).
2. Remove the workstation blade.
3. Remove the WS460c Graphics Expansion Blade access panel ("WS460c Graphics Expansion Blade
access panel" on page 29).