HP ProLiant WS460c G6 Workstation Blade with WS460c Graphics Expansion Blade Maintenance and Service Guide

Removal and replacement procedures 72
11.
Install the graphics cards, and then connect any power cables to the graphics cards. If you are installing
only one graphics card, you must install it in slot 1, the lower slot, and then install a filler card in slot 2.
12. Install the graphics card retainer by sliding the retainer under the lip at a slight angle (1). As you push
forward, the retainer straightens out, and then the clips connect to the Graphics Expansion Blade
chassis (2).
13. Install the Graphics Expansion Blade PCIe card cage:
a. Engage the PCIe card cage to the anchoring pins on the expansion blade enclosure.
b. Attach the two T-15 screws that secure the front of the PCIe card cage.
14. Install the four PCIe/SAS cables.
15. Install the Graphics Expansion Blade.
16. Install the Graphics Expansion Blade access panel.
17. Install the workstation blade.
18. Power up the workstation blade.
19. Download and install the latest drivers from the HP website
(http://www8.hp.com/us/en/support-drivers.html) or the NVIDIA website
(http://www.nvidia.com/content/drivers/drivers.asp).
For software installation information on the HP ProLiant WS460c Workstation Blade with WS460c Graphics
Expansion Blade, see the Administrator's Guide for Microsoft Windows on HP ProLiant Blade Workstations.
The installation is complete.