HP ProLiant WS460c G6 Workstation Blade with WS460c Graphics Expansion Blade Maintenance and Service Guide

Removal and replacement procedures 59
System board
To remove the component:
1. Power down the workstation blade (on page 26).
2. Remove the workstation blade (on page 28).
3. Remove the access panel ("Access panel" on page 28).
4. Remove all hard drives ("Hard drive" on page 39).
5. Remove all hard drive blanks ("Hard drive blank" on page 39).
6. Remove the hard drive backplane ("Hard drive backplane" on page 45).
7. Remove the front panel/hard drive cage assembly ("Front panel/hard drive cage assembly" on page
46).
8. Remove all DIMMs.
9. Remove all mezzanine cards, if installed ("Mezzanine card" on page 44).
10. Remove the heatsink ("Heatsink" on page 51).
11. Open the processor locking lever and the processor socket retaining bracket.
12. Using the processor tool, remove the processor from the system board:
a. Line up the processor tool, ensuring the locking lever graphic on the tool is oriented correctly.
b. Press in on the plastic tabs, and then place the tool on the processor.