HP ProLiant WS460c G6 Workstation Blade with WS460c Graphics Expansion Blade Maintenance and Service Guide

Removal and replacement procedures 58
6.
Apply all the grease to the top of the processor in the following pattern to ensure even distribution.
CAUTION: To avoid damage to the system board, processor socket, and screws, do not
overtighten the heatsink screws. Use the wrench supplied with the system to reduce the possibility
of overtightening the screws.
7. Align and install the heatsink. Alternate tightening the screws until the heatsink is seated properly.
8. Install the front panel/hard drive cage assembly ("Front panel/hard drive cage assembly" on page
46).
9. Install the hard drive backplane ("Hard drive backplane" on page 45).
10. Install the hard drives ("Hard drive" on page 39).
11. Install the hard drive blanks ("Hard drive blank" on page 39).
12. Install the access panel ("Access panel" on page 28).
13. Install the workstation blade.