HP ProLiant WS460c G6 Workstation Blade with WS460c Graphics Expansion Blade Maintenance and Service Guide

Removal and replacement procedures 30
2.
Disconnect the four PCIe/SAS cables from the PCIe riser board, noting the location for reinstallation.
3. Remove the two Torx-15 screws that secure the graphics expansion blade to the workstation blade (1).
4. To remove the graphics expansion blade from the workstation blade, carefully pull up on the front and
right sides of the PCIe card cage to disengage it from the anchoring pins on the expansion blade
enclosure (1), and then lift the PCIe card cage out of the expansion blade enclosure (2).
To reinstall the blade, follow these steps in reverse order.
WS460c Graphics Expansion Blade PCIe card cage
To install another graphics card, you must remove the PCIe card cage from the WS460c Graphics Expansion
Blade. To remove the card cage:
1. Remove the WS460c Graphics Expansion Blade access panel ("WS460c Graphics Expansion Blade
access panel" on page 29).