Quick Deploy Rail System Installation Instructions

Installing the cable management arm
IMPORTANT: If you need to hinge the cable management arm
on the rear right-hand side of the rack, see the instructions
in “Converting the cable management arm for opposite side
mounting.” Perform these steps to convert the arm to a right-hand
swing and install the arm on the right side of the rack.
IMPORTANT: If installing the cable management arm in a rack
with a rack rail adapter, install the cable management arm in the
rail adapter position as shown in the following fi gure.
IMPORTANT: If installing the cable management arm in a rack
without a rack rail adapter, install the cable management arm in
the primary position by pressing the tab and sliding the arm back
as shown in the following fi gures.
The installation is complete.
If the rack installation is to be shipped with product(s) installed, perform the
steps in “Preparing the product for rack relocation or integrated shipping.”
Converting the cable management arm
for opposite side mounting
The cable management arm is designed for ambidextrous implementation.
You can convert the arm for right-hand swing.
NOTE: To access some components on the rear of the product, you may
need to remove the cable management arm.
IMPORTANT: When converting the cable arm, always be sure to
orient the arm with the cable trough facing upward.
Preparing the rails for integrated shipping
in a rack
Use the integrated shipping hardware included with this kit to prepare a
rack for integrated shipping.
Return to step 1 in “Installing the product in a rack.”
Preparing the product for rack relocation
or integrated shipping
To service or remove the product from the rack, reverse the steps in this
section:
1. Remove the rear slide locking screw and the front rail locking screws.
Retain the screws for future use.
2. Cut and discard the orange tie wraps.
Documentation feedback
HP is committed to providing documentation that meets your needs. To help
us improve the documentation, send any errors, suggestions, or comments
to Documentation Feedback (mailto:[e-mail]). Include
the document title and part number, version number, or the URL when
submitting your feedback.