HP ProLiant SL210t Gen8 Plus Server Maintenance and Service Guide

Removal and replacement procedures 35
To remove the component:
1. Power down the node (on page 22).
2. Disconnect all peripheral cables from the node.
3. Remove the node from the chassis (on page 23).
4. In a 1U node configuration:
a. Remove the 1U cable guard (on page 27).
b. Remove the 1U air baffle (on page 28).
5. In a 2U node configuration:
a. Remove the PCI riser cage (on page 24).
b. Remove the 2U adapter board bracket (on page 26).
c. Disconnect and remove the Mini-SAS cable ("Remove the Mini-SAS cable" on page 26).
d. Remove the 2U air baffle (on page 29).
6. Remove the heatsink ("Heatsink" on page 41).
7. Open each of the processor locking levers in the order indicated, and then open the processor retaining
bracket.