HP ProLiant SL170z G6 Server Maintenance and Service Guide

Contents 76
Table 10 POST Error Messages
Error Code
Error Message
Description/Corrective Action
010h Floppy Controller Failure
The floppy controller initialized
failed, the devices could not use
normally
012h CMOS Date/Time Not Set
The CMOS Date and/or Time
are invalid. This error can be
resolved by readjusting the
system time in the Setup Utility.
048h Password check failed
Password is incorrect after retried a
few times. Users might need to reset
the password.
04Ch Keyboard/Interface Error
Keyboard controller failed test. This
may indicate a problem with system
hardware.
05Dh
S.M.A.R.T. Status BAD, Backup and
Replace
Hard Disk S.M.A.R.T feature test
fail, indicate a problem with hard
disk
05Eh Password check failed
If user input incorrect password
more than three times, then display
this error information and continue
to boot.
110h
Un-correctable DRAM ECC Error
detected at
cpuXX/DIMM0X(cpu01/DIMM08)
Detect multi-bit error in the DIMM
prompt, press F1 continue to boot
613h
Power supplies mismatch, replace
slot#2 with identical Power supply
Press F1 to continue booting with
one power supply
When two power supplys are
installed, if their vendors are
different, this will appear and
system will halt.
604h System Fan 1 Missing
If system fan1 is not installed or
failed, system will announce this
message and system will shutdown
in minutes.
605h System Fan 2 Missing
If system fan2 is not installed or
failed, system will announce this
message and system will shutdown
in minutes.
606h System Fan 3 Missing
If system fan3 is not installed or
failed, system will announce this
message and system will shutdown
in minutes.