HP ProLiant SL165z G6 Server Maintenance and Service Guide

Contents 73
Table 14 POST error messages
Error code
Error message
Description/corrective action
628 Uncorrectable Memory
ECC Error -
DIMM_J11J12
Set the Memory Channel Mode as “Independent” and the
Uncorrectable Memory ECC error occurred on the DIMM_J11 or
DIMM_J12, then replace the broken DIMM
629 Uncorrectable Memory
ECC Error -
DIMM_J13J14
Set the Memory Channel Mode as “Independent” and the
Uncorrectable Memory ECC error occurred on the DIMM_J13 or
DIMM_J14, then replace the broken DIMM
62A Uncorrectable Memory
ECC Error -
DIMM_J100J101
Set the Memory Channel Mode as “Independent” and the
Uncorrectable Memory ECC error occurred on the DIMM_J100 or
DIMM_J101, then replace the broken DIMM
62B Uncorrectable Memory
ECC Error -
DIMM_J102J103
Set the Memory Channel Mode as “Independent” and the
Uncorrectable Memory ECC error occurred on the DIMM_J102 or
DIMM_J103, then replace the broken DIMM
62C Uncorrectable Memory
ECC Error -
DIMM_J104J105
Set the Memory Channel Mode as “Independent” and the
Uncorrectable Memory ECC error occurred on the DIMM_J104 or
DIMM_J105, then replace the broken DIMM
62D Uncorrectable Memory
ECC Error -
DIMM_J106J107
Set the Memory Channel Mode as “Independent” and the
Uncorrectable Memory ECC error occurred on the DIMM_J106 or
DIMM_J107, then replace the broken DIMM
Checking NVRAM
Update Failed
BIOS could not write to the NVRAM block. This message appears
when the FLASH part is malfunctioning.
Operating system not
found
 Operating system cannot be located on any of the boot
drives.
 Verify that the priority boot drive has power and that the IDE
cable is connected properly.
 Verify that the desired boot drive has power
 Verify that the IDE cable is securely plugged into the
respective system board connectors.
 Verify that the boot device is enabled in the Setup Utility.
 Verify that the boot device has an operating system installed.
 If the problem persists, contact your Foxconn Customer
Support provider.