HP ProLiant SL165z G6 Server Maintenance and Service Guide

Contents 50
Device number
Connector
System fan 1 J6 on the AC power board
System fan 2 J8 on the AC power board
System fan 3 J10 on the AC power board
System fan 4 J11 on the AC power board
RJ45 cable
connector
J1 on the AC power board
UID cable
connector
J12 on the AC power board
A new system fan can be installed to allow the server to operate properly in case a default system fan
becomes defective.
To remove the system fan:
1. Disconnect the fan cable from its corresponding board connector.
2. Lift the system fan away from the chassis.
Figure 35 Removing the system fan