ProLiant ML570 Generation 4 Server Maintenance and Service Guide

Removal and replacement procedures 52
11.
Move the locking switch to the locked position.
12. Configure the memory.
13. Install the access panel.
14. Do one of the following:
o Install and lock the bezel.
o Slide the server back into the rack.
Memory board cage
To remove the component:
1. Power down the server (on page 28).
2. Do one of the following:
o Unlock and remove the bezel ("Tower bezel" on page 29).
o Extend the server from the rack (on page 28).
3. Remove the access panel ("Access panel" on page 31).
4. Remove all memory boards ("Removing and installing a memory board (hot-plug)" on page 47,
"Removing and installing a memory board (non-hot-plug)" on page 50).
5. Remove the center wall ("Center wall" on page 41).