HP ProLiant ML570 Generation 2 Server Setup and Installation Guide

Troubleshooting
HP ProLiant ML570 Generation 2 Server Setup and Installation Guide D-7
HP CONFIDENTIAL
Writer: Wendy Wing File Name: m-appd Troubleshooting.doc
Codename: Time Bandit Part Number: 223960-002 Last Saved On: 8/22/02 11:24 AM
Table D-3: Is the System Power LED Green?
Answer Possible Reasons Possible Solutions
No, it is off Power On/Standby button has not
been pressed firmly.
Firmly press the power button.
A power supply problem exists. The
power supply may not be connected or
inserted properly, it may have a
damaged connector, or it may have
failed.
Be sure that the power supply is
undamaged, the power supply is fully
seated, and the power supply LED is
green.
The system may have experienced a
short.
Check for bent connector pins and
improperly seated expansion boards.
The front panel LED assembly has
failed.
Be sure that the front panel LED
assembly cable is connected to the
power backplane.
If these solutions do not solve the
problem, contact your HP authorized
service provider for assistance.
Yes If the system power button LED is green, refer to Table D-4.
Note: For LED locations and functions, refer to Appendix C, “ System LEDs and Switches.” For
cabling configurations, refer to Chapter 7, “Cabling the Server.”