HP ProLiant ML570 Generation 2 Server Memory Installation Guide

Memory
Installing a DIMM
To install a DIMM:
1. Remove the memory board. Refer to “Removing a Memory Board” in this
chapter.
2. Observe all DIMM installation requirements for your desired memory mode.
Refer to the “DIMM Installation Requirements” section for each mode in this
chapter.
IMPORTANT: Follow all DIMM configuration requirements carefully. If the DIMMs are not
configured properly, you receive an error message during POST and the DIMM LEDs
flash amber.
3. Align the keyed portion of the bottom edge of the DIMM with the tab in the
DIMM slot.
4. Press the DIMM firmly into the slot (1) and push the latches into place (2).
Figure 1-6: Installing and latching a DIMM
IMPORTANT: The bottom edge of the DIMM is designed so that it fits into the DIMM slot only
one way.
1-28 HP ProLiant ML570 Generation 2 Server Memory Installation Guide
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: b-ch1 Memory.doc
Codename: Seabiscuit Part Number: 279987-003 Last Saved On: 5/8/03 8:58 AM