Compaq ProLiant ML530 Setup and Installation Guide

Server Installation 3-15
Compaq Confidential – Need to Know Required
Writer: Tricia Acevedo Project: Compaq ProLiant ML530 Setup and Installation Guide Comments:
Part Number: 139006-002 File Name: d-ch3 Installation.doc Last Saved On: 6/15/00 9:02 AM
IMPORTANT: To make the installation of the mounting bracket easier, attach the bracket
rail to the rack mounting bracket before attaching the mounting bracket assembly to the
rack. This way, the joined mounting bracket and bracket rail can be fastened to the rack
as one assembly.
Attaching the Bracket Rail to the
Mounting Bracket
Read all of the following steps before you begin.
1. Unpack the hardware mounting kit.
2. Lay the two-piece slide rail assembly (outer bracket rail and inner
component rail) and fasteners on a flat surface along with the mounting
brackets and fasteners that came with the rack.
3. Extend the component rail from the bracket slide rail until the
component rail release latch clicks. Holding down the latch, slip this
piece out of each bracket rail, as shown in the Figure 3-8.
Figure 3-8. Removing the ProLiant ML530 component rail from the bracket
rail