Compaq ProLiant ML530 Setup and Installation Guide

Installing Hardware Options 2-19

Compaq Confidential – Need to Know Required

Writer: Tricia Acevedo Project: Compaq ProLiant ML530 Setup and Installation Guide Comments:

Part Number: 139006-002 File Name: c-ch2 Installing Hardware.doc Last Saved On: 6/13/00 12:29 PM

Replacing the CD-ROM Drive

To replace the CD-ROM drive, follow the instructions included in the drive

kit.

1. Remove the access panel, as described in the section, “Accessing

Processors and the System Board,” earlier in this chapter.

2. Remove the CPU system fan. Press in on the locking latch and pull the

fan out of the CPU system fan cage.

3. Remove the CPU fan basket. See section in Chapter 2, “Replacing the

Diskette Drive.”

4. Remove the cables from the back of the CD-ROM drive.

5. Loosen the thumbscrew .

6. Release latch by pushing the latch toward the outside of the system.

7. Push the drive out through the front of the server .

Figure 2-17. Removing the CD-ROM drive

8. Align the new CD-ROM drive into position from the front of the server.

9. Push the drive into the bay until it stops.

10. Slide the latch back into locked position and tighten the thumbscrew.