ProLiant ML530 Generation 2 Server Setup and Installation Guide

Contents
HP ProLiant ML530 Generation 2 Server Setup and Installation Guide ix
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: a-frnt.doc
Codename: Seattle Slew Part Number: 225579-002 Last Saved On: 1/8/03 2:56 PM
System Maintenance Switch ...................................................................................C-21
Non-Maskable Interrupt Switch..............................................................................C-22
System Configuration Settings......................................................................................C-22
Appendix D
Troubleshooting
When the Server Does Not Start .................................................................................... D-3
Diagnostic Steps ............................................................................................................. D-5
Problems After Initial Boot .......................................................................................... D-11
ROMPaq Disaster Recovery......................................................................................... D-14
Other Information Resources ....................................................................................... D-15
Appendix E
Server Specifications
Appendix F
System Battery
System Board Battery Replacement................................................................................ F-1
Index
List of Figures
1-1 HP ProLiant ML530 Generation 2 tower-model server............................................ 1-3
1-2 HP ProLiant ML530 Generation 2 rack-model server.............................................. 1-4
2-1 ProLiant ML530 Generation 2 servers installed in a rack ........................................ 2-1
2-2 Rack-mounting hardware........................................................................................ 2-10
3-1 Front view of the tower model with the front bezel door removed and
front view of the rack model..................................................................................... 3-5
3-2 Rear view of the tower-model and rack-model server .............................................. 3-6
3-3 Opening the front bezel door on the tower-model server ......................................... 3-7
3-4 Locating and removing the Torx T-15 tool............................................................... 3-9
3-5 Removing the front bezel door ............................................................................... 3-10
3-6 Removing the access panel (tower server).............................................................. 3-11
3-7 Locating the hot-plug door key............................................................................... 3-12
3-8 Unlocking and opening the hot-plug door .............................................................. 3-13
3-9 Removing the processor air baffle .......................................................................... 3-15