ProLiant ML530 Generation 2 Server Setup and Installation Guide

PCI-X Technology
4-26 HP ProLiant ML530 Generation 2 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: e-ch4 PCI-X Technology.doc
Codename: Seattle Slew Part Number: 225579-002 Last Saved On: 1/8/03 3:14 PM
Novell NetWare Operating System Messages
Novell NetWare uses the following list of messages to indicate errors during
PCI Hot Plug operations:
• Expansion Board Not Same—The expansion board is not the same as the
expansion board being replaced. The hot-plug replacement cannot continue.
• Card Functioning—The expansion board in the slot is currently functioning.
The Add/Replace is ignored.
• Driver in Use—The expansion board is currently in use. Do you wish to force
removal?
• Driver Loaded—The driver for the expansion board is currently loaded and
must be unloaded manually. Unload the driver and select again.
• General Failure—Could not perform the action because of a system failure.
• No Hot-Plug Driver—The hot-plug driver is not responding. Check to be sure
the device driver CPQSBD.NLM is loaded.
• Remove Not Supt—The Remove action is not supported for the expansion
board/slot.
• Switch Open—The slot cannot be initialized because the switch is open. Close
the switch and try Add/Replace again.
• Unknown Slot—The Add/Remove was performed on an unknown slot. Try the
command again.
• Replace Load Driver—The expansion board is successfully replaced. Please
load the driver at this time.