ProLiant ML530 Generation 2 Memory Installation Guide

Memory
1-20 HP ProLiant ML530 Generation 2 Server Memory Installation Guide
HP CONFIDENTIAL
Writer: Wendy Wing File Name: b-ch1 Memory.doc
Codename: Seattle Slew Part Number: 279985-002 Last Saved On: 1/9/03 11:54 AM
Installing a DIMM
To install a DIMM:
1. Remove the memory board. See “Removing a Memory Board” in this chapter.
2. Observe all DIMM installation requirements for your desired memory mode. See
the “DIMM Installation Requirement” section in this chapter for each mode.
IMPORTANT: Follow all DIMM configuration requirements carefully. If the DIMMs are not
configured properly, you receive an error message during POST and the DIMM LEDs
blink amber.
3. Align the keyed portion of the bottom edge of the DIMM with the tab in the
DIMM slot.
4. Press the DIMM firmly into the slot (1) and push the latches into place (2).
Figure 1-5: Installing and latching a DIMM
IMPORTANT: The bottom edge of the DIMM is designed so that it fits into the DIMM slot only
one way.