HP ProLiant ML370 Generation 3 Setup and Installation Guide

Installing Hardware Options
3-20 HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: d-ch03 Installing Hardware Options.doc
Codename: Dizzy Devil Part Number: 281992-002 Last Saved On: 12/3/02 12:45 PM
Rack Server
To extend the server from the rack and remove the access panel:
1. If the server is operating, power down the server. Refer to “Powering Down the
Server” in this chapter.
NOTE: Some hot-plug hardware options may be installed without powering down the
server or removing the access panel.
2. Loosen the two thumbscrews that secure the bezel to the front of the rack (1).
3. Extend the server from the rack until the sliding rails lock (2).
Figure 3-16: Extending the server from the rack