HP ProLiant ML370 Generation 3 Setup and Installation Guide

Installing the Rack Server
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide 4-23
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: e-ch04 Installing the Rack Server.doc
Codename: Dizzy Devil Part Number: 281992-002 Last Saved On: 12/3/02 2:12 PM
Extending the Server from the Rack
To extend the server from the rack:
1. Loosen the thumbscrews that secure the front bezel to the front of the rack (1).
2. Extend the server on the rack rails until the spring-load rail lock engages (2).
Figure 4-18: Extending the server from the rack
3. After performing the installation or maintenance procedure, press the tabs on the
ends of both server rails and slide the server back into the rack.
4. Tighten the thumbscrews to secure the server in the rack.
5. Refer to “Installing the Server in the Rack” in this chapter for detailed
instructions.
For information concerning routine maintenance and safety precautions, refer to the
Documentation CD provided with the server.