Compaq ProLiant Clusters for SCO UnixWare 7 U/200 Quick Install Guide for the Compaq ProLiant ML350

Installing Cluster Software 3-7
Compaq Confidential – Need to Know Required
Writer: Rachel Williams Project: Compaq ProLiant Clusters for SCO UnixWare 7 U/200 Quick Install Guide for the Compaq ProLiant ML350
Comments: Part Number: 223094-001 File Name: d-ch3 Installing Cluster Software.doc Last Saved On: 12/27/00 10:31 AM
Installing Node 1
To install the Quick Install software on node 1, use the following steps:
NOTE: To save time, you can install both nodes together. Be sure node 1 has rebooted
before rebooting node 2. Insert the CDs into the servers, power up the servers, and then
follow the procedures for each node at the same time.
1. Power up node 1, and then insert the Quick Install CD for node 1 into
the CD-ROM drive. Wait while node 1 boots from the CD. A warning
message indicates that data will be lost.
2. Press Enter to continue, or power down the system to abort the
installation.
The software begins to load and a progress bar indicates the installation
progress. When all software has been loaded, several screens request
necessary information.
3. Provide the necessary information for the following screens. Each
screen displays the fields and a brief description of each field as it is
selected for entry. For detailed help, press F1.
a. Read responses from previously saved diskette?
This screen provides the opportunity to restore responses from a
previous installation.
G Use the arrow key to select No to skip reading responses or if this is
the first installation. Responses can be saved later.
G Use the arrow key to select Yes to read the answers from a diskette
and present them as defaults in the remaining screens.
G Use the arrow key to select Force to read the answers from a diskette,
and then apply them without modification. The date is assumed to be
correct on the system and is not modified.
b. Date, Time, and Time Zone
Modify the current date, time, and time zone as necessary. Only U.S.
time zones are available during Quick Install. Time zone information
can be changed after Quick Install by using the UnixWare
SCOadmin system administration tools. For more information, see
the “Understanding Preinstallation Tasks and Considerations”
section earlier in this chapter.
c. Cluster name
Enter the name of the cluster.