Compaq ProLiant Clusters for SCO UnixWare 7 U/200 Quick Install Guide for the Compaq ProLiant ML350

Installing Cluster Software 3-5
Compaq Confidential – Need to Know Required
Writer: Rachel Williams Project: Compaq ProLiant Clusters for SCO UnixWare 7 U/200 Quick Install Guide for the Compaq ProLiant ML350
Comments: Part Number: 223094-001 File Name: d-ch3 Installing Cluster Software.doc Last Saved On: 12/27/00 10:31 AM
Configuring the Servers with SmartStart
After you have set up the BIOS, configure the server with SmartStart. To
configure the server nodes using SmartStart:
1. Select the language at the prompt. The Regional Settings screen displays.
2. Select the country and keyboard type from the Regional Settings screen.
3. Set the date, time, and daylight savings time adjustment if applicable.
4. Click Next, and then click Continue. The License Agreement displays.
5. Accept the License Agreement to continue. A configuration selection
window displays.
6. Select Manual Configuration in the Installation Path area, and click Begin.
7. Click the plus sign (+) preceding the SCO entry in the menu. A list of
operating systems displays.
8. Select SCO UnixWare 7.1.1, and then click Next. A warning screen displays.
9. Click Continue. Wait while the system configuration loads and a
partition is created. A
Create Support Software screen displays.
10. Click Next.
11. Remove the SmartStart CD, and then click Continue.
12. Repeat the procedures for erasing the configuration (if necessary) and
configuring servers on node 2. If you have completed these procedures
on node 2, continue with the following section to install the cluster using
the U/200 Quick Install CDs.