HP ProLiant ML350 Generation 4p Server Maintenance and Service Guide

Removal and replacement procedures 21
•
Extend the server from the rack ("Extending the server from the rack" on page 13).
3. Remove the access panel ("Access panel" on page 14).
4. Disconnect the redundant system fan cable from the redundant system fan connector on the system
board.
5. Remove the fan.
To replace the component, reverse the removal procedure.
Expansion slot cover
To remove the component:
1. Power down the server ("Powering down the server" on page 13).
2. Do one of the following:
• Unlock and remove the bezel ("Front bezel (tower model)" on page 15).
• Extend the server from the rack ("Extending the server from the rack" on page 13).
3. Remove the access panel ("Access panel" on page 14).