ProLiant ML350 Generation 3 Server Setup and Installation Guide

Index
S
removable media device blanks
removing 3-9
safety standards
replacing 3-9
IEC 825 A-9
removable media drives, number
supported 1-4
laser compliance A-9
sales website 2-9
removing
screws 2-7
access panel (rack) 3-7
SCSI
access panel (tower) 3-6
ID, setting E-13
bezel 3-4
jumper settings E-13
DIMMs 3-33
SCSI adapter wide-to-narrow,
illustrated 4-6
expansion board retainer,
illustrated 3-23
SCSI adapter, installing 4-6
memory modules 3-33
SCSI cable, illustrated 4-3
PPM (Processor Power Module) 3-46
SCSI cables location, illustrated 4-8
removable media device blanks 3-9
SCSI device cabling, illustrated 4-7
tape drive 3-20
SCSI device guidelines 4-2
replacing
SCSI devices
access panel (tower) 3-6
additional information 4-4
bezel 3-5
connecting SCSI controller to removable
media or other device 4-7
lithium battery 3-47
removable media device blanks 3-9
connector, identified 4-10
system board battery 3-47
Fast SCSI-2, installing 4-6
resources See also documentation
SCSI hard drives, installation
guidelines 3-12
CarePaq D-14
HP ProLiant ML350 Generation 3
Server Maintenance and Service
Guide D-14
security
diskette write control 5-4
Insight Manager 5-11
Servers Troubleshooting Guide D-14
network server mode 5-6
ROM
passwords 5-5
flashing 5-9
Quicklock 5-6
System Firmware Update 5-13
security features 1-17
updating 3-34
serial number, setting 5-4
upgrading 5-13
server
ROM Based Setup Utility See RBSU
cabling 2-27
ROM Selection, RBSU option 5-7
cabling guidelines 4-1
ROMPaq
configuration 2-33, 5-1
diskette, creating 5-10
configuration and management
tools 1-16
overview 5-9
server features 1-16
data back up 3-3
round-hole racks, server installation 2-20
disk controller 1-13
Index-8 HP ProLiant ML350 Generation 3 Server Setup and Installation Guide
COMPAQ CONFIDENTIAL
Writer: Richard O. Heath File Name: x-index.doc
Codename: Steel Venom Part Number: 316354-002 Last Saved On: 8/21/03 10:30 AM