HP ProLiant ML350 Generation 3 Server Maintenance and Service Guide

Removal and Replacement Procedures
Hot-Plug Hard Drive
NOTE: The server does not need to be powered off to complete this operation.
To remove a hot-plug hard drive:
1. Open the bezel door. Refer to “Bezel Door (Tower Model Only)” earlier in this chapter.
2. Slide the hard drive release latch (1) to open the ejector lever (2).
3. Pull the hot-plug hard drive out of the drive bay.
1
2
Figure 2-18: Removing a hot-plug hard drive
To replace a hot-plug hard drive, push the drive back into the bay and then close the ejector
lever to fully seat the drive.
HP ProLiant ML350 Generation 3 Server Maintenance and Service Guide 2-21