ProLiant ML310 Generation 2 Server Maintenance and Service Guide

30 HP ProLiant ML310 Generation 2 Server Maintenance and Service Guide
2. Prepare the heatsink for installation:
– If reusing the heatsink, clean the bottom of the heatsink with the provided
alcohol pad, then apply a thin layer of thermal grease to the top of the
processor.
– If installing a new heatsink, remove the protective covering.
3. Install the heatsink fan assembly.
CAUTION: Heatsink retaining screws should be tightened in
diagonally opposite pairs (in an "X" pattern).
4. Connect the fan cable to the system board.
5. Install the access panel.
6. Install the bezel.
Diskette drive
CAUTION: To prevent improper cooling and thermal damage, do
not operate the server unless all bays are populated with either a
component or a blank.
To remove the component:
1. Power down the server ("Powering down the server" on page 15
).
2. Remove the bezel ("Bezel" on page 17
).