ProLiant ML310 Generation 2 Server Maintenance and Service Guide

Removal and replacement procedures 27
Power supply
To remove the component:
1. Power down the server ("Powering down the server" on page 15
).
2. Remove the bezel ("Bezel" on page 17
).
3. Remove the access panel ("Access panel" on page 20
).
4. Remove the air baffle ("Air baffle" on page 25
).
5. Disconnect the power and data cables.
6. Remove the power supply.
To replace the component, reverse the removal procedure.
Processor assembly
IMPORTANT: To avoid damage to the processor and system
board, only authorized technicians trained by HP should attempt to
replace or install the processor in this server.
To remove the component:
1. Power down the server ("Powering down the server" on page 15).