ProLiant ML150 Server NOS Installation and Software Guide

Installing Turbolinux 8 Server
3. Select the type of your mouse, and click Next.
4. Select the destination for the installation.
5. Click Automatic partitioning to configure the partition automatically.
Or, if you are not using an empty hard disk, click TFDisk to configure partition
manually by the following procedure:
a. Click Remove All to remove the partition, and click OK.
b. Select DOS Free, and click Add a partition, then OK.
Set the parameters as follows:
Partition Type: Linux ext3
Mount Point: /boot
Size(in megabytes): (by default value)
Click OK.
c. Select DOS Free, and click Add a partition, then OK.
Set the parameters as follows:
Partition Type: Linux swap
Mount Point: swap
Size(in megabytes): (2 x server memory size)
Click OK.
d. Select DOS Free, and click Add a partition, then OK.
Set the parameters as follows:
Partition Type: Linux ext3
Mount Point: /
Size(in megabytes): (by default value)
Click OK.
e. Click Next to continue.
f. When the “Choose partitions to format” message appears, click OK.
8-2 HP ProLiant ML150 Server NOS Installation and Software Guide
HP CONFIDENTIAL
Writer: Pauline Tsai File Name: i-ch8 Installing Turbolinux 8 Server.doc
Codename: Stone Soup Part Number: 343330-002 Last Saved On: 11/10/03 12:33 PM