ProLiant ML150 Server NOS Installation and Software Guide

Installing Microsoft Windows 2000 Server and Small Business Server 2000
5. Configuring the network
6. Installing MSM
Section 1. Creating the Driver Diskette
1. Insert one blank, formatted 3.5” diskette into the flexible diskette drive of a PC
running Microsoft Windows.
2. Insert the HP Startup CD-ROM into the CD-ROM drive of the above PC and
follow the on-screen instructions to create the Windows 2000 SCSI driver
diskette (HP disk W2K SCSI).
NOTE: If the PC does not auto-start the Startup menu, start it by opening startup.htm, found
at the root level of the Startup CD-ROM.
Section 2. Performing Windows 2000 Installation
NOTE: Though you may install Windows 2000 from setup diskettes or directly from the
Windows 2000 CD-ROM, we recommend you use the second method because it is faster.
1. Boot the new server from the Windows 2000 CD-ROM.
2. You will see a message that reads, Setup is inspecting your hardware
configuration
. Then the setup screen will be displayed.
3. Always press F6 when the system briefly shows the message of Press F6 if you
need to install a third party SCSI or RAID controller at the bottom of the
display.
NOTE: Unfortunately, Windows 2000 setup only gives you a short time to press the F6 key. If
you miss it, reboot the system and start from step 1 above.
a. Press the S key to specify additional SCSI adapters.
b. When prompted, insert the HP disk W2K SCSI you created from the HP
Startup CD-ROM.
c. Press the Enter key to continue.
2-2 HP ProLiant ML150 Server NOS Installation and Software Guide
HP CONFIDENTIAL
Writer: Pauline Tsai File Name: c-ch2 Installing Microsoft Windows 2000 Server and Small Business Server 2000.doc
Codename: Stone Soup Part Number: 343330-002 Last Saved On: 11/10/03 12:31 PM