ProLiant ML150 Server NOS - (English) Installation and Software Guide

Installing SCO Open UNIX 8
Installing the SCSI Driver
1. Insert the SCO Open UNIX 8 AIC-7902W SCSI driver (HP ProLiant ML150
SCO Open UNIX 8 SCSI drivers) diskette you created from the HP Startup CD-
ROM. Select Install HBA diskette and press the F10 key to load the diskette.
2. After loading the diskette, select Proceed with installation, and press the F10
key.
Installing the Operating System
1. Select Do not enter the DCU (auto-configure drivers), and press the F10 key.
2. Enter the node name for your system, and press the F10 key.
3. Select Install from CD-ROM, and press the F10 key.
4. Press the F2 key to select Customize partitions for disk configuration, and press
the Enter key.
On the Disk 1 Partitions page, configure the following settings:
a. Press the F2 key to select UNIX System in the Type field, and press the
Enter key.
NOTE: The system must have one UNIX system partition.
b. Press the Tab key to move to the Status field, and press the F2 key to select
the Active option.
NOTE: The UNIX system partition must be set to Active.
c. Press the Tab key to move to the % field, and enter the percentage value (for
example, 10) of the UNIX system on your hard disk.
d. Press the Tab key to move to the Size field, and the system will
automatically calculate the specified size of the hard disk.
NOTE: The UNIX system partition must be at least 80MB.
e. Press the F10 key to return to the Customize partitions page.
HP ProLiant ML150 Server NOS Installation and Software Guide 10-3
HP CONFIDENTIAL
Writer: Pauline Tsai File Name: k-ch10 Installing SCO Open UNIX 8.doc
Codename: Stone Soup Part Number: 343330-003 Last Saved On: 1/7/04 4:13 PM