ProLiant ML150 Server NOS - (English) Installation and Software Guide

Installing Turbolinux 8 Server
Mount Point: swap
Size(in megabytes): (2 x server memory size)
Click OK.
d. Select DOS Free, and click Add a partition, then OK.
Set the parameters as follows:
Partition Type: Linux ext3
Mount Point: /
Size(in megabytes): (by default value)
Click OK.
e. Click Next to continue.
f. When the “Choose partitions to format” message appears, click OK.
6. Uncheck the Create boot disk item if you do not want to create a boot disk.
Make sure to check the Install boot loader item. Accept the default setting for
the destination of the boot loader. Then click Next.
7. Configure your network now. If you want to allocate the network, uncheck the
Configure using DHCP item and enter your network configuration. Make sure
the Activate on boot item is checked. Then click Next.
NOTE: If the Activate on boot item is checked but the server is not connected to a network,
the server will take a few more minutes when rebooting after the installation.
8. Set the time zone (America/New York as the default setting), and click Next.
Default is America/New York.
9. Enter the root password (at least 6 characters) and re-enter it. Click Next.
NOTE: The screen will display Not matched when you re-enter the wrong password.
10. Select the type of the installation, and click Next.
11. Select the manufacturer and model for your monitor, and click Next.
12. Configure your X Windows settings, and click Next.
NOTE: You can click Test this configuration to test your configuration.
HP ProLiant ML150 Server NOS Installation and Software Guide 8-3
HP CONFIDENTIAL
Writer: Pauline Tsai File Name: i-ch8 Installing Turbolinux 8 Server.doc
Codename: Stone Soup Part Number: 343330-003 Last Saved On: 1/7/04 3:56 PM