ProLiant ML150 Server NOS - (English) Installation and Software Guide

Installing Turbolinux 8 Server
Section 1. Performing the Turbolinux 8 Server
Installation
Booting
1. Turn on the server and insert the Turbolinux 8 Server CD-ROM.
2. On boot prompt, press the Enter key.
3. After loading the SCSI driver, select a language (English as the default setting)
and press the Enter key to begin the installation.
Installing the Operating System
1. Accept the default setting for the type of the installation, and click Next.
2. Select the type of your keyboard, and click Next.
3. Select the type of your mouse, and click Next.
4. Select the destination for the installation.
5. Click Automatic partitioning to configure the partition automatically.
Or, if you are not using an empty hard disk, click TFDisk to configure partition
manually by the following procedure:
a. Click Remove All to remove the partition, and click OK.
b. Select DOS Free, and click Add a partition, then OK.
Set the parameters as follows:
Partition Type: Linux ext3
Mount Point: /boot
Size(in megabytes): (by default value)
Click OK.
c. Select DOS Free, and click Add a partition, then OK.
Set the parameters as follows:
Partition Type: Linux swap
8-2 HP ProLiant ML150 Server NOS Installation and Software Guide
HP CONFIDENTIAL
Writer: Pauline Tsai File Name: i-ch8 Installing Turbolinux 8 Server.doc
Codename: Stone Soup Part Number: 343330-003 Last Saved On: 1/7/04 3:56 PM