ProLiant ML150 Server NOS - (English) Installation and Software Guide

Installing Red Hat Linux 9.0 Professional
2. If you chose DHCP, you can skip to step 7. Otherwise, deselect Configure using
DHCP.
3. Enter the IP address and netmask that corresponds to your network. Click OK
4. Repeat steps 1 through 3 for each NIC.
5. Select manually for Set the host name and enter a host name for your machine
(e.g., HP-server1).
6. Enter any required addresses for Gateway, Primary, Secondary, and Tertiary
DNS.
7. On the Firewall Configuration screen, choose the type of firewall configuration,
or No Firewall for none. If configuring a firewall, you may choose Use default
firewall rules, or Customize. Click Next to continue.
NOTE: If you accidentally chose to install a firewall, and did not intend to, you can “rm
/etc/rc.d/rc[0-5].d/*iptables*” & “iptables –F” from the root pr ompt later to get rid of it.
More Installation Settings
1. On the Additional Language Support screen, select English (USA). Click
Next.
2. On the Time Zone Selection screen, select your location. Click Next.
3. On the Set Root Password screen, type in the root password and confirmation.
Click Next to continue.
Package Group Selection
1. Select the appropriate package groups for your installation. Click Next to
continue.
2. Click Next to begin the installation.
3. The installation should begin. The installation time will vary depending on your
hardware configuration. You can monitor the progress from the Installing
Packages screen. Depending on the packages selected, it may then eject the CD-
ROM and prompt you for the next CD-ROM. Insert the next CD-ROM, and click
OK.
HP ProLiant ML150 Server NOS Installation and Software Guide 4-5
HP CONFIDENTIAL
Writer: Pauline Tsai File Name: e-ch4 Installing Red Hat Linux 9.0 Professional.doc
Codename: Stone Soup Part Number: 343330-003 Last Saved On: 1/7/04 3:52 PM