ProLiant ML150 Server NOS - (English) Installation and Software Guide

Installing Red Hat Linux 9.0 Professional
7. Click New.
a. For Mount Point, enter
/.
b. Be sure File System Type: is set to ext3.
c. Be sure that only your boot device is selected under Allowable Drives.
d. Set Additional Size Options to Fill to maximum allowable size.
e. Select Force to be a primary partition.
f. Click OK.
g. Click Next.
Boot Loader Configuration
1. Click the checkbox for Configure advanced boot loader options.
2. Click Next.
3. Click Change Drive Order.
4. Highlight the drive you are booting to with the mouse and click on the up arrow
to move it up to the top of the list. You may need to select the drive and click on
the up arrow several times until it is on the top of the list.
5. Click OK.
6. You may need to enter special kernel parameters here.
7. Click Next.
Network Configuration
NOTE: The installer should have detected all of your NICs at this point. If it does not, then you
may need to obtain a special NIC driver that may be installed after you have completed the
Red Hat Linux installation.
1. If you are using DHCP, then click next. Otherwise, select your first NIC and
click
Edit.
4-4 HP ProLiant ML150 Server NOS Installation and Software Guide
HP CONFIDENTIAL
Writer: Pauline Tsai File Name: e-ch4 Installing Red Hat Linux 9.0 Professional.doc
Codename: Stone Soup Part Number: 343330-003 Last Saved On: 1/7/04 3:52 PM